|
C30 / S40 & V50 '04-'12 / C70 '06-'13 General Forum for the P1-platform C30 / S40 / V50 / C70 models |
Information |
|
Light load hesitation.Views : 622 Replies : 12Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jun 25th, 2024, 09:57 | #1 |
Premier Member
Last Online: Jul 28th, 2024 14:31
Join Date: Apr 2013
Location: Plymouth
|
Light load hesitation.
2.0d on 160k.
I recently changed my Glow Plugs and found the EGR was sticking. I cleaned it up and refitted. I was also having an oil level increase on long journeys. I then realised my DPF was due a change and the EOLYS a refill New DPF fitted and EOLYS refilled. That has sorted the rising oil level( obviously through failed regens) The EGR still threw the occasional fault codes. So I did an Oil and Filter change as well as fitting a new EGR. Oil level now stays constant and there are no fault codes at all( apart from AQ sensor.) I have for a while been getting a slight hesitation, small surging under light loads. Early on it tended to be whilst the engine is warming up but recently most of the time under very light loads. Ie on the motorway in the 50 limit. Around town in traffic. Under acceleration all feels good. I am planning on doing some live readings to see if I can narrow down the issue.I am just after some advice on possible parameters to monitor to try and narrow down the failing sensor/ component. When I do the Injector cut out test all appears fine and all the same. I did think it could be related to the EGR but now a new one has been fitted I can hopefully rule that out. And advice on parameters to monitor would be welcome. Volvo Fuel filter and air filter recently changed.
__________________
V50 2005. 2.0D |
Jun 25th, 2024, 12:25 | #2 |
Member
Last Online: Yesterday 04:52
Join Date: Aug 2017
Location: Denmark
|
Did you wipe the EGR adaption values in Vida as per the instructions after fitting the new valve?
In Vida: DIAGNOSTICS/CAR COMMUNICATION/Advanced/ECM/Adapting EGR-valve --- I'm still struggling with my 2.0D regenerating as soon as it can, which is every 115 km or so, resulting in rising oil level. I've about given up on it now. |
Jun 25th, 2024, 14:55 | #3 | |
Premier Member
Last Online: Jul 28th, 2024 14:31
Join Date: Apr 2013
Location: Plymouth
|
Hi
Quote:
Yes, 99% sure, can't quite remember the terminology but something to do with EGR adaptions, Will look later and double check. My Eolys tank was empty(now full) and I think the DPF was due for replacement(now replaced). Since then no rising oil levels.
__________________
V50 2005. 2.0D |
|
Jun 25th, 2024, 15:17 | #4 |
Premier Member
Last Online: Yesterday 21:32
Join Date: Mar 2017
Location: Manchester
|
you could run the egr adaptation again did you also reset the counter for the eloys adm... egr duty cycle can be viewed with vida on a graph so you can compare with the suggested parameters that vida shows. also have you reset the oil quality sensor there is a revised oil capacity of 4.8 ltr which allows a little oil dilution before messages flag up. its an unfortunate fact that diesels with dpfs are not suitable for certain types of driving/
|
Jun 25th, 2024, 16:23 | #5 | |
Premier Member
Last Online: Jul 28th, 2024 14:31
Join Date: Apr 2013
Location: Plymouth
|
Hi
Quote:
I reset service reminder but didn't see oil quality sensor?? Could that be the later V50's?? I reset the service reminder. I only put in about 4.6 or 4.7 lts. About 1/4" down from max. Will have a look for oil quality sensor and have a look at the EGR duty cycle Thanks.
__________________
V50 2005. 2.0D |
|
Jun 25th, 2024, 16:54 | #6 |
Member
Last Online: Yesterday 04:52
Join Date: Aug 2017
Location: Denmark
|
I'll try refilling my Eolys tank again, I bought a 3 litre bottle of the stuff on Ebay when I bought the car and the last two times I've tried to fill it, it was nearly full. Last time was about 18 months ago, I've driven about 50K km since then.
|
Jun 25th, 2024, 17:21 | #7 |
Premier Member
Last Online: Jul 28th, 2024 14:31
Join Date: Apr 2013
Location: Plymouth
|
Hi
I did actually take my tank off to fill it !! I think I must have reset the counter at some point and it was always reading full. I just wanted to check it was empty before I filled it. It took the full bottle (1lt) i think. I then refitted the tank and reset the counter, will wait and see if the level drops (in VIDA) over the next few months. There is a prime function in VIDA for the pump as well
__________________
V50 2005. 2.0D |
Jun 25th, 2024, 17:47 | #8 | |
Member
Last Online: Yesterday 04:52
Join Date: Aug 2017
Location: Denmark
|
Quote:
The second time, I had the indie mechanic I use to do it just to make certain I wasn't doing it wrong and he hooked things up the way I had with the same result. So, it's possible something related to the additive system just isn't working. I know the Eolys pump is working since I can hear it running when I prime it from Vida, but maybe it isn't activated when I fill up the fuel tank with diesel. Simmy, do you know how it registers that diesel has been added? Is it like the 1.6D where it uses a magnet in the filler cap? Sorry for posting questions about my car in your thread, Iain. |
|
Jun 25th, 2024, 22:28 | #9 |
Premier Member
Last Online: Yesterday 21:32
Join Date: Mar 2017
Location: Manchester
|
im not sure its not anything iv needed to know possibly a message sent from the level float.. clan may be able to answer this question
|
Jun 25th, 2024, 22:36 | #10 | |
Premier Member
Last Online: Yesterday 21:32
Join Date: Mar 2017
Location: Manchester
|
Quote:
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|